1.The result shows that the proposed design method is simple, reasonable and easy to apply as compared with the conventional design methods.
实例分析表明，本文所提出的设计方法比传统设计方法简单易行、结果合理。
2.The feasibility of this approach is validated in the conventional design and optimization of cylinder bearing system.
这种方法的有效性在圆轴承的常规设计和优化设计中得到验证。
3.By PSPICE simulation it is shown that the performance of proposed circuit is much better than the conventional design.
PSPICE模拟表明所提出的电路与其它同类电路相比具有更好的电路特性。
4.Just because of all this, the conventional design of port distinct with the operation fact of modern Container Terminal.
这使得传统的码头设计方法所得的结果与现在的码头实际运作效果存在较大的差别。
5.The result shows that the volume of the reducer can be reduced by 64. 8% using this method, comparing with the conventional design.
计算结果表明，采用可靠性优化设计与常规设计相比，使该减速器体积减小64.
6.Eight grid molds of the conventional design are mounted, equally spaced along the table top's circular edge.
八个普通结构的板栅模具，沿工作台顶部周边间隔相等。
7.The safety-factor-method, currently, is commonly applied in conventional design and calculation.
常用的设计计算方法主要是安全系数法。
8.The comparison between conventional design and solid modeling by UG is made by an example of IR window.
以红外窗口为例，对常规平面设计方法和UG实体模型方法进行对比。
9.the pile spacing might not satisfy the condition of reliability design even though they could meet the conventional design.
按常规设计条件得到的抗滑桩间距，不一定满足可靠性设计条件。
10.in the conventional design , springs , axially maintained the sleeves in te center position.
在传统的设计中，采用弹簧来将轴套轴向保持在中心位置。